Return to site

Publishing Salt Spray Check Samples to the Laboratory

After the samples are organized it should be made clear to the screening laboratory what the salt spray test demands are and probably more to the point, what the post-test evaluation demands are. Often when the products have done the salt spray exposure they have to be evaluated for extreme, rusting, pitting, etc.

The lab must have understanding of the post-test evaluation techniques and specific pass/fail standards for each sample. Would be the samples being tested as an investigation software? It's perhaps not unusual for various base components and/or films to be put through salt spray publicity to find out the effects of the material/coating improvements in stopping corrosion.

These kind of tests tend to be done with routine checks to record the condition of the samples throughout salt spray exposure. These checks are often done everyday all through normal opening and ending of the salt spray chamber. Excessive trouble of the salt spray test may have a negative impact on the validity of the test so these advanced inspections must be held at a minimum.

Normal test cells are generally afflicted by salt spray exposure while suspended at a specific angle to straight in the chamber. Do the tests have to be documented in virtually any unique methods? It is perhaps not exceptional for salt spray chamber to be an interest in saving the test benefits beyond the information acquired all through standardized post-test evaluations.

Pieces and units will usually have significantly more unpredictable geometries and treatment must be taken when they're put in the check step in order that "puddling" of the salt solution does not happen on the part surfaces - appropriate continuous drainage is quite important. The direction of the pieces and units in the step is usually done in ways that it mimics the alignment once the portion or assembly is placed in service.

The most common documentation is the use of photographs. The photos can be put into the final check record which is often commonly and simply spread so the true check samples do not have to be seen in person. It is important to share with the lab workers prior to the check begins what type of paperwork is likely to be required.

Electrical tests can also be executed on electric assemblies which can be afflicted by salt spray publicity - these kinds of samples could be pre-wired and the products may be examined as the samples have been in the step being put through the salt spray publicity (with the cables being run beyond your step through the water seal).